It was made from a duo rope tightener.
A 3mm hole was drilled thru the plastic on both sides.
A 3mm aluminium rod of length 180mm was inserted thru the holes.
The rod was then ergonomically shaped to comfortably hold mecha kits of up to 1/100 in scale.
Due to the reduced interior space, the internal spring was taken out, modified and replaced.
To fit the Torso Grip onto a bendy spine, just squeeze the tightener on both ends and slot it on the spine.
Height adjustment is also done in a similar fashion.
Let's check it out.
(click for larger image)
Front:
Side:
Rear:
Top:
Looking more & more like the Bandai Gunpla Stand ei?......don't ya think?
posted by Laurens @ 2:15 AM
3 Comments:
nice piece of work!i think u need larger clips from army market.
not smiley ones.
Actually i think the one i used is a little too large,looking for smaller ones. Black also. But the lobang must remain the same.
You ought to make one Nexus Stand ver.2 for your friend! My EPYON is waiting to soar.
Post a Comment
<< Home